NewPIC+ - New Portable Intelligent Collector plus -

NewPIC+ for the microtremor measurement consists of the main unit (amplifier and A/D converter) and the sensor unit as followings.

Basic configuration During measurement

  1. Appearance
         Main unit: 12cm(W) × 10cm(D) × 8cm(H) (without projection)
         Sensor: 9cm(W) × 9cm(D) × 6cm(H) (without projection)
  2. Power Supply
         AC Power: AC/DC converter (Input AC100-240V)
         Battery: 6 AA Alkaline Batteries for approximately 6 hours
  3. Amplifier
         Input: ±2.5V
         Impedance: 10kΩ
         Amp gain: 0dB, 20dB, 40dB, 60dB (selectable from software)
  4. Filter
         High passed filter: 5Hz, 10Hz, 20Hz (selectable from software)
  5. A/D Converter
         Resolution: 22Bit
         Dynamic range: 112dB
         Numbers of channel: 3 channels (X, Y, Z)
         Sampling rate: 100Hz
  6. Communication
         Interface: RS422
         Baud rate: 19,200bps
         Data bit: 8bit
         Stop bit: 1bit
         Parity bit: Non parity
         Protocol: Non procedural
  7. Control
         CPU: 32bit RISC microcomputer
  8. Acquisition system
         Display: 8.9inch TFT
         Memory: 16GB
* The characteristics above-mentioned changes not with a guaranteed value but with observation conditions.


  System and Data Research Co., Ltd.

1991- Copyright © System and Data Research Co.,Ltd. ALL RIGHTS RESERVED.